Online Catalogue | EMACSYS
Items: Value:
Product Sections:
Main Pages:
Ref: EM-Cont
Quantity:
The Control Module is the heart of the EMACSYS range. This module contains the main processor plus all the interfaces to the peripherals as well as the main USB interface for downloading applications.For more information this and other EMACSYS modules see EMACSYS web site. Here you will also find all documentaion and application downloads.Related products:
Ref: EM-Eth10
This module brings 10Base-T ethernet connectivity to the EMACSYS system. Connection to the EMACSYS Control module is via a 10 way ribbon cable (supplied). Status of the ethernet connection is shown on the yellow and red LEDs mounted on the RJ45 ethernet connector. For applications requiring web pages a 128 MByte EEPROM is provided.Related products:
Ref: EM-Mod
This module provides a means of controlling EMACSYS system outputs and reading inputs via the mobile phone network. Connection to the EMACSYS Control module is via a 10 way ribbon cable (supplied). Connection to an antenna is via a standard SMA connector. Provision is made for a user provided SIM card.A suitable antenna is also available.Related products:
Ref: EM-OPT
This module is usually used as an output connector although it equally suitable for use with single-ended inputs, such as logic levels. Each output has a single terminal with the ground line brought out as a referance.Related products:
Ref: EM-IPT
Usually used as an input connector this module has two terminals for each input, one connected to the input, the other to the ground line. This makes the module suitable for inputs using clean switch or relay contacts.Note that this connector block may also be used for output connections.Related products:
Ref: EM-AIP
This module is used with the Analogue inputs on the EMACSYS Control Module. Each input has 2 terminals. The positive input is connected to the internal supply rail via a jumper and a 10K resistor. This makes it suitable for direct connection to passive sensors such as thermistors.Related products:
Ref: EM-RS232
This module adds RS232 capability to the EMACSYS Control module. Connection is via a 10 way ribbon cable (supplied). Related products:
Ref: VR1
The Relay Expansion Module connects directly to our range of VIOM, NETIOM and EMACSYS products. It has 8 single pole change over relays each rated at 1 amp d.c. at 24 Volts d.c. /110 Volts a.c. Connection to the module is via a 10 way ribbon connector (provided) which carries the eight output lines plus power.Related products:
Ref: VO1C
The Optoisolation Input Module connects directly to the digital inputs of our range of VIOM, NETIOM and EMACSYS products. It has 8 optoisolators for systems which require a high level of isolation and noise immunity. Two versions are available, one with a common optoisolator supply rail, the other with each optoisolators supply separate. Connection to the module is via a 10 way ribbon connector (provided) which carries the eight output lines plus power.Related products:
Ref: VD1
The LED Display Module connects directly to our range of VIOM, NETIOM and EMACSYS products. It has 8 x 3mm red LEDs. Connection to the module is via a 10 way ribbon connector (provided) which carries the eight output lines plus power.As well as display functions, the module is also very useful as an installation / diagnostic aid.Related products: